NEO continues the hardware design of NEO V2, upgrade the GNSS module to Ublox NEO M9N, supports Beidou, Galileo, Glonas and GPS receive at the sameWeight0.5 kgDimensions10 10 5 cmProtocolUART/IO/I2CGNSS receiverUblox M9NGNSS concurrentlybeidou,galileo,glon
Flash Sale Ongoing
NEO continues the hardware design of NEO V2, upgrade the GNSS module to Ublox NEO M9N, supports Beidou, Galileo, Glonas and GPS receive at the same
| Weight | 0.5 kg |
|---|---|
| Dimensions | 10 10 5 cm |
| Protocol |
UART/IO/I2C |
| GNSS receiver |
Ublox M9N |
| GNSS concurrently |
beidou,galileo,glonass,gps |
| positioning accuracy |
0.7M |
| Compass |
IST8310 |
| Nav.update rate |
25MHZ |
| Remote Control Peripherals/Devices |
GPS |
| For Vehicle Type |
Airplanes |
| Plastic Type |
ABS |
1 Ublox M9N satellite receiver, accuracy up to 0.7m
2 Support BDS, GALILEO, GLONASS, GPS four satellite systems
3 Support simultaneous reception of four satellite systems
4 Triple filters design
NEO 3 is a cost-effective M9N navigation and positioning product with a single point positioning accuracy of up to 0.7m. It integrates positioning system, magnetic compass, controller status light, controller alarm, and barometer, and can receive signals from four major satellite navigation and positioning systems simultaneously
Product Parameters |
|
| Compass | ST8310 |
| RGB Drive | NCP5623 |
| Buzzer | Passive buzzer |
| Safety Switch | Physical button |
| GNSS Receiver | UBLOX NEO M9N |
| Number of Concurrent GNSS | 4(BDSGALILEOGLONASSGPS) |
| Frequency Band | GPS:L1C/A GLONASS:L10F BDS:B11 GALILEO:E1B/C |
| GNSS Augmentation System | SBAS:WAAS,EGNOS,MSAS QZSS:L1s(SAIF) other:RTCM3.3 |
| Horizontal Accuracy | 2.0m |
| Speed Accuracy | 0.05m/s |
| Nav.update rate | 25Hz(Max) |
| Acquisition | Cold start:24s Hot start:2s Aided start:2s |
| Number of Saellites(MAX) | 32+ |
| Sensitivity | Trackng and nav-167dBm Cold start Hot start-148dBm Reacquisition-160dBm |
| Protocol | UART+IO+l2C |
| Port Type | GHR-10V-S |
| Supported Controller | CUAV series, Pixhawk series |
| Wave Filtering | SAW+LNA+SAW |
| Anti-Lectromagnetic/Radio FrequencyInterference | EMI+RFI |
| Upgrade Firmware | Support |
| Support Control Type | ArduPilot/PX4*(PX4 is stillworking hard to adapt to the clock) |
| Input Voltage | 4.7-5.2V |
| Operating Temperature | -1070 |
| Size | 606016mm |
| Weight |
33g |
Reviews
There are no reviews yet.