This PM uses I2C digital signal data output, only compatible with Pixhawk 5X/6X series.

PM06D provides regulated power supply for your Pixhawk 5X & 6X from thebattery,as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Specification

• Input voltage: 2S- 14S
• PCB Cont.Current Rating: 70A
• PCB BurstCurrent Rating: 120A (<60 Sec)
• Max current sensing:327A
• Voltage and current monitor with I2C compatible interface
• Connector Outputs: 5.2V and 3A max
• Weight: 24.5g
  

Current Rating:

The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly.

PX4 Parameter Setup:

If you are using thePM06D 14S version, you must setSENS_EN_INA228to enable.

Package Includes

1x PM06D Power Module1x 6pin 2.00mm pitch cable