Overview

Holybro RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module.
The products run open-source firmware (ArduRemoteID) and provides a so-calledstandard Remote ID solution,primarily target drone manufacturers & system integrators.

Specification

• Radio module:
• Espressif ESP-C3 module
• Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)
• FCC&CEcertified radio module
• Firmware:
• ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).
• Supports upgrading firmware via the web interface (OTA)
• Supported in PX4 & Ardupilot
• Protocol: CAN & Serial
• Interface:
• 1x JST GH 4-pin CAN (CAN) port
• 1x JST GH 6-pin TELEM (UART) port
• Antenna Connector type:
• On CNC Case: SMA connector
• On PCB: IPEX Connector
• Range: > 5km detection range*
• Power: 5V supplied from TELEM or CAN port
• LED lights: Bright RGB status LED
• Size:
• Without case: 35.3 x 23.5 mm (not including antenna)
• With CNC case: 38 x 26.5 x 11.5 mm (not including antenna)
• Mount: M2 screws
• Operating temperature: -40C to +85C
• Weight:
• PCB only: 4 g
• With CNC case & Antenna: 27.5g
• Without case & Antenna: 16.5g (Cable 20cm)
• Certification:FCC&CE

* The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible.

PINMAP

Package Includes

• 1x Remote ID
• 1x Antenna
• 1xJST GH 6pin 150mmCable
• 1xJST GH 4pin150mmCable